Author Archives: Patrick Jaromin
Mahogany and Padauk Neck
Before routing the neck pocket in the body, we need a neck. This guitar again features a Gibson-style angled headstock made with a scarf joint. The bulk of this neck will be African Mahogany like the body. For this guitar I decided to also laminate a “racing stripe” down the center of the neck. A … Continue reading
Atomic Age Surfcaster
With the charity guitar (the “Wishcaster”) complete, it’s time to start the next build. Though I still haven’t completed the acoustic, I really want to build another Surfcaster – this time for me. A few weeks ago I acquired three burl Maple bookmatched caps for the next few guitars. Perhaps it’s the fact that during … Continue reading
Final Assembly and Setup
Once the finish cured, I sanded with wet/dry paper starting with 400 grit and then working up to 2000. After than, I polished it with brown jeweler’s rougue and buffed it out to a high-gloss near-mirror sheen. I attached the neck, installed the pickguard and bridge, and then attached the strap pins and tuners. For … Continue reading
Wiring the Wishcaster’s Electronics
A primary difference between this guitar and the previous two is the electronics wiring and installation. The Surfcaster is wired like a Stratocaster — with the pickups and controls attached to the pickguard instead of directly to the body. This greatly simplifies installation and makes it possible to work on the electronics and the finish … Continue reading
Dyeing the Wishcaster Blue
With the neck now attached, it was time for a quick trip to quality control – my eldest son Sean – for a check. Thankfully it passed and so the project moved forward to making the pick guard. Pickguard construction began, as usual, with templates. They were prepared from 1/2″ MDF using the full-size drawing. … Continue reading
Carving the Wish-caster Neck
After a couple weeks away, I was finally able to spend a weekend in the shop. Returning to the fretboard, I gave it a bit of thought and ultimately decided rather than try and fix the bad frets (there were probably 8-10) and paint the fretboard with CA (see the previous post), I would basically … Continue reading
The “Wish-caster” Fingerboard
The Design The first two electrics I built were constructed with factory-made necks. Having never fretted an instrument before, I was apprehensive about taking on that part of the project with a hard deadline. For this design I wanted a custom inlay on the fretboard featuring the primary ‘star’ component of the Make-a-Wish logo. Last … Continue reading
Make-A-Wish Surfcaster: Capping the Body
With the Ash blank shaped, it’s time to prepare the figured top. I made a “top cap” template including holes for the sound hole and electronics pockets. Two of these were cut: one in MDF and another in acrylic. I wanted a clear version to allow me to see the grain pattern I was selecting for the … Continue reading
Make-A-Wish Charvel Surfcaster: Starting the Build
In 2014 I had the idea that I could build an electric guitar (my first) and raffle it off for charity through my company’s holiday party band, the LCA. This resulted in the LCA SG Jr. guitar which raised over $2,100 for Make-A-Wish Illinois. Last year this was repeated with a Lospennato-inspired “Radio star” clone, … Continue reading
Assembling the Box, Part I – Soundboard and Sides
The head and tail blocks The head block was assembled as a 5-piece glue-up with three ‘core’ pieces stacked vertically and a top and bottom glued horizontally cross-grain. This is done to promote stability and strength in both dimensions while providing a side-grain surface for both the sides and the top and bottom. The top of the … Continue reading