Monthly Archives: March 2008
An Hour Here, a Half-Hour There and a Few Saturday Mornings
Over the past month I found very little contiguous time to make progress on the shop setup. Consequently I never felt like I had made significant enough progress in any given week to warrant a new post. While I’m still quite some distance from the finish line, I finally feel like I can actually say, … Continue reading
Hacking the Delta 50-875
(This post is based on a LumberJocks.com forum thread.) After completing my dust collection system installation, I turned to my air cleaner, the Delta 50-875. I had decided to install it just above my table saw — about 2/3rd’s of the way along the wall, where the intake would be in line with the front … Continue reading
Custom Collector Controller
If you read my last post you might recall how I decided to purchase an X10 “Powerflash Interface” to test out as a controller for my dust collector. My skepticism about how the unit worked turned out to be well-founded. The Powerflash device sends an X10 “on” signal when 6-18VDC is applied to the contacts … Continue reading